The Wall Angle Roll Forming Machine is a high degree of automation and
full-featured forming machine, which can improve product quality, enhance
efficiency and reduce labor intensity of workers, and at the same time promote
the technological progress of the entire industry in this production field.
According to the Cold Roll Forming Machine Manufacturer, the 11 key processes used by
the roll forming machine are as follows:
1. When the Roll Forming Machine Rolls the conical workpiece, the small round end of the workpiece is pressed against the guide roller of the vertical roller.
2. The steel plate is not allowed to run when the steel plate is bent. When the hydraulic pressure of the hydraulic station is unstable or the oil temperature and bearing temperature exceed 60°C, work is not allowed.
3. When rolling, there is no slippage between the steel plate and the work roll; when rolling or leveling, the steel plate should be placed in the middle of the work roll, and the thickness of the steel plate should be reduced accordingly when offset.
4. When the steel plate is flattened with a pad, the hardness of the pad should not be higher than the hardness of the work roll. Care must be taken not to roll or flatten the protruding weld or cut the edge of the steel plate.
5. Before starting the roll forming machine, check all parts for abnormalities. The tightening nut must not be loose. The brake should be normal and reliable. Adjust the reel distance strictly according to the thickness of the plate. Workpieces within performance limits.
6. During operation, the workpiece must be placed steadily, and then it can only be driven to operate after the position is correct, and the signal should be clear and a person should be appointed to direct it.
7. When the roll forming machine is in operation, the hand cannot be placed on the rolled steel plate, nor can it be inspected with a model. After stopping, use the model to check the roundness. When rolling a workpiece that is not perfectly round, a certain margin should be left when rolling to the end of the steel plate to prevent the workpiece from falling and hurting people.
YC Metal Sheet Rolling Door Roll Forming Machine
8. When the roll forming machine is in operation, it is forbidden to stand on the workpiece, and no roundness can be found on the rolled cylinder.
9. Rolling thick, large-diameter cylinders or workpieces with high material strength should be rolled down, rolled and rolled several times. When rolling a narrow cylinder, it should be placed in the middle of the roll for rolling.
10. After the workpiece enters the roll of the roll forming machine, it should prevent the hands and clothes from being caught in it.
11. If there is any abnormal noise in the operation of the machine after the roll forming machine is stopped, it should be checked and repaired immediately. After the roll forming machine is stopped, the workpiece should be placed in the designated place.
