With the development of science and technology, the use of cold roll forming machine equipment has become a mainstream product in today's society. Its advantages and cost-effectiveness are loved by customers and are widely accepted. Do you understand cold roll forming machines? What is the machine used for? How is it composed? The advantages of characteristics determine the performance. The following Door Roll Forming Machine Supplier will show you the relevant knowledge of cold roll forming machines.
Door Roll Forming Machine
Cold roll forming machine is a new type of equipment for tunnel support steel arch frame processing. It consists of six parts: base, mechanical transmission, cold bending system, hydraulic system, electrical control system and auxiliary system.
When the Cold Roll Forming Machine is working, the profiled steel to be cold-formed is pushed by the portal bracket of the auxiliary system between the two active rollers. When the design required radians are reached, the hydraulic system is closed, the mechanical transmission system is started, the active roller is rotated, and the profile steel is moved forward slowly and smoothly by friction to achieve continuous cold bending operations. At the end of the cold bend, the mechanical transmission system is closed, and the hydraulic system is started at the same time, so that the hydraulic cylinder is retracted. Simply place the cold-formed steel on the door bracket of the auxiliary system.
The cold bending operation not only guarantees the strength of the material but also improves the quality of the supporting steel arch frame, which greatly improves the work efficiency, and the operation is simple and clear. Compared with the press, the cold roll forming machine has good working performance.
As such a device, of course, there are some places that need special attention when using it, so the precautions should be fully prepared before using the cold forming machine equipment. The Cold Roll Forming Machine Manufacturer is briefly introduced below. What are the common points of attention?
First, before use, be sure to choose a flat surface for placement to ensure that the machine is stable. Then, pull the chassis feet apart for easy observation. Then insert the plug into the panel and tighten it by rotation. Secondly, the plug at one end is plugged into the panel at the back of the chassis, and the other end is plugged into a power source, and it is generally required to use a single-phase three-wire power supply, and then turn on the main power switch behind the chassis, and then operate according to a certain mode and implement Adjust to a certain value. Finally, wait until the green indicator light comes on, and a prompt sound appears, then start the next work, sealing work, and then check the quality of the seal, and operate according to different materials to ensure that the quality of the seal is the best good.